Versions Compared

Version Old Version 2 New Version 3
Changes made by

Chris Kite

CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID584
KitDescCoin and Card

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID959
KitDescCard Only

  1. Remove existing coin drop.

  2. Install C-0913 Drop Coverwhere the coin drop was previously installed. Secure in place with C-1062 Kep Nuts.

  3. Place theC-6700-TEMPDrill Template on the desired mounting location.

  4. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  5. Refer to for further instructions.

Connect Power

Cci readerinstall kit
KitID802
KitDescTap Machine Source Power
  1. Tap the machine AC power wires using theC-5101Spade Taps.
    1. For120vmodels:L1,N, andGroundwires
    2. For240vmodels:L1,L2, andGroundwires
  2. Connect the three wires from the C-5210 Power Adapter Harnessto theC-5101 Spade Taps.
    1. Connect theBluewire to the L1tap.
    2. Connect the Brownwire to the N/L2tap.
    3. Connect theGreen/Yellowwire to the Groundtap.
  3. Connect the 3-pinconnector from the C-5210 Power Adapter Harnessto the matching connector on the C-5602R1 Power Converter.
  4. Connect the 4-pinconnector from theC-5602R1 Power Converterto the matching connector on theC-5500-60Power Extension Harness.
  5. Run the C-5500-60Power Extension Harness to the reader mounting location.

Connect Coin Sense Harness

Cci readerinstall kit
KitID722
KitDescFactory - Optical Coin Drop
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect theC-6368 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID664
KitDescPulse - Phase 7
  1. Connect theC-5369R1Machine Start Harness to theCoin 1connector on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of theC-5369R1 Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. (Coin and Card Installation Only) Connect the free end of the C-6368 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of the C-5500-60 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.
Cci readerinstall footer