Place theC-5700-TEMPDrill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to for further instructions.
Connect Power
Cci readerinstall kit
KitID
993
KitDesc
Tap Source Machine Power
Tap power as described in the document by connecting theC-5336Power Adapter Harnessto the power distribution terminal block inside the machine.
Use C-5101 Spade Tap on a L1 and L2 power wire.
Connect the C-5336 Power Adapter Harness.Blue wire to L1 and Brown to L2.
Connect the Green/Yellow wire to the ground screw.
Connect the opposite end of theC-5336Power Adapter Harnessto theC-5602R1Power Converter.
Connect theC-5500-115Power Extension Harness to the appropriate connector on theC-5602R1Power Converter. The remaining cable end connects to the FasCard reader.
Connect Coin Sense Harness
Cci readerinstall kit
KitID
679
KitDesc
Factory - Optical Coin Drop
Disconnect the Coin Drop from the Machine Control Assembly.
Connect theC-5258Coin Sense Harness to the harness connected to the Coin Drop.
Connect Machine Interface Harness
Cci readerinstall kit
KitID
578
KitDesc
Serial
Connect theC-0127-MLVMachine Start Harness to theP9 - Serialconnection on the Machine Control Assembly.
Connect and Mount Reader
Multiexcerpt include
SpaceWithExcerpt
CCIDOC
MultiExcerptName
F1 Reader
PageWithExcerpt
_Reader Ports
Feed remaining harness ends through the mounting hole.
Connect the free end of the C-0127-MLVMachine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
(Coin and Card Installation Only) Connect the free end of theC-5258Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
Connect the free end of theC-5500-115 Power Extension Harness to port 4 (Power Harness Connection Port) as shown in the image above.