Page Comparison

Cci readerinstall header

Cci readerinstall kit

KitID	584
KitDesc	Coin and Card

Place theC-6700-TEMPDrill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to for further instructions.
Optional: Apply C-5033 Labelover coin drop opening.

Cci readerinstall kit

KitID	994
KitDesc	Card Only - Card Model

Place theC-6700-TEMPDrill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to for further instructions.
Optional: Apply C-5033 Labelover coin drop opening.

Cci readerinstall kit

KitID	598
KitDesc	Card Only - Coin Model

Remove existing coin box and coin mechanism.
Run reader harnesses through the metercase and out the opening where the coin mechanism was mounted.
Attach the C-5414 Reader Bracketto the C-6911 Metercase Bracketusing (2)C-542010-32 x 1/4 Pan Screws.
Insert the reader harnesses through the hole in the C-6911 Metercase Bracketand then insert the bracket into the metercase opening.
Secure the C-6911 Metercase Bracket to the metercase using the C-0301Mounting Bolt.

Cci readerinstall kit

KitID	595
KitDesc	Tap Machine Power

Use the C-5101 Spade Tapson the incoming power.
1. Tap theL1wire.
2. Tap theNwire.
3. Tap theGround wire.
Take the C-5210 Power Adapter Harnessand connect the red tab connectors to the following wires:
1. Connect thebluewire to theL1wire.
2. Connect thebrownwire to theNwire.
3. Connect the green/yellow wire to theGroundwire.
Connect the 3-pin connector from the C-5210 Power Adapter Harnessto the matching connection on the C-5602R1Power Converter.
Connect the4-pinconnector from the C-5602R1 Power Converterto the matching connection on the C-5500Power Extension Harness.

Cci readerinstall kit

KitID	721
KitDesc	Factory Coin

Disconnect the Coin Drop from the Machine Control Assembly.
Connect theC-6362 Coin Sense Harness to the harness connected to the Coin Drop.

Cci readerinstall kit

KitID	590
KitDesc	Pulse - AA3 Connection

Connect the C-5364 Machine Start Harnessto the AA3connection on the machine control assembly.

Multiexcerpt include

Feed remaining harness ends through the mounting hole.
Connect the free end of the C-5364 Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
(Coin and Card Installations Only) Connect the free end of the C-6362 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.

Multiexcerpt include

Cci readerinstall footer

Versions Compared