Versions Compared

Old Version 2

changes.mady.by.user Chris Kite

Saved on

compared with

New Version 3

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID598
KitDescCard Only - Coin Model

  1. Remove existing coin box and coin mechanism.

  2. Run reader harnesses through the metercase and out the opening where the coin mechanism was mounted.

  3. Attach the C-5414 Reader Bracketto the C-6911 Metercase Bracketusing(2)C-542010-32 x 1/4 Pan Screws.
  4. Insert the reader harnesses through the hole in the C-6911 Metercase Bracketand then insert the bracket into the metercase opening.
  5. Secure the C-6911 Metercase Bracket to the metercase using the C-0301Mounting Bolt.

Connect Power

Cci readerinstall kit
KitID595
KitDescTap 120v Machine Power
  1. Use the C-5101 Spade Tapson the incoming power.
    1. Tap theL1wire.
    2. Tap theNwire.
    3. Tap theGround wire.
  2. Take the C-5210 Power Adapter Harnessand connect the red tab connectors to the following wires:
    1. Connect thebluewire to theL1wire.
    2. Connect thebrownwire to theNwire.
    3. Connect the green/yellow wire to theGroundwire.
  3. Connect the 3-pin connector from the C-5210 Power Adapter Harnessto the matching connection on the C-5602R1Power Converter.
  4. Connect the4-pinconnector from the C-5602R1 Power Converterto the matching connection on the C-5500Power Extension Harness.

Connect Machine Interface Harness

Cci readerinstall kit
KitID1003
KitDescPulse - AA3 Debit Connection
  1. Connect the C-5364 Machine Start Harnessto the AA3connection on the machine control assembly.
  2. Connect the C-0128-MBJ Jumper Pluginto the harness connected to theVault Switch.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of the C-5364 Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.

Machine Configuration

Multiexcerpt include
SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
MultiExcerptNameMayTag Gen1 MLV+ Pulse
PageWithExcerpt_Machine Configuration

Cci readerinstall footer