Versions Compared

Old Version 2

changes.mady.by.user Chris Kite

Saved on

compared with

New Version 3

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID584
KitDescCoin and Card

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID845
KitDescCard Only

  1. Remove existing coin box and coin drop.

  2. Secure C-5414 F2 Mounting Bracketto the C-6903Mounting Bracket using the(2)C-542010-32 x 1/4 Pan Screws.

  3. Install theC-6903Mounting Bracketinto theCoin Vault. Use (4) C-1042Kep Nuts to secure toCoin Vault.

Connect Power

Cci readerinstall kit
KitID663
KitDescTap Machine Power
  1. Tap power as described in the document using theC-5101 Spade Taps provided.
  2. Connect theC-5336 Power Adapter Harness to the installed spade taps-BluetoBlack and BrowntoRed. Secure the green ground terminal under the bolt on top of the washer drum.
  3. Connect the opposite end of theC-5336Power Adapter Harnessto theC-5602 Power Converter.
  4. Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID923
KitDescCoin Drop - Factory Optical
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect theC-6332 Coin Sense Harness to the harness connected to the Coin Drop.
    1. Connect the Redconnector to the Coin Acceptorconnection, where the coin drop was previously connected, on the Machine Control Assembly.

Connect Machine Interface Harness

Cci readerinstall kit
KitID608
KitDescSerial
  1. Connect the C-0114-MLV Machine Start Harness to the middle X1 port on the serial communication board.
    CCIDOCCOM Boardsfalse

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of the C-0114-MLV Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. (Coin and Card Installation Only) Connect the free end of the C-6332 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.

Machine Configuration

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameContinental ProfitPlus
PageWithExcerpt_Machine Configuration

Cci readerinstall footer