Versions Compared

Old Version 2

changes.mady.by.user Chris Kite

Saved on

compared with

New Version 3

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID584
KitDescCoin and Card

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID1011
KitDescCard Only

  1. Remove the existing payment device panel and put aside the fasteners securing the panel in place.

  2. Place the C-5414 Standard Mounting Bracket over the front of the C-6971 FC Mounting Bracket so the three large, circular openings align and attach using the(2) C-542010-32 x 1/4" Screws.
  3. Install the C-6971 FC Mounting Bracket into the payment device panel opening. Secure in place using the factory fasteners.

Connect Power

Cci readerinstall kit
KitID802

  1. Tap power as described in the document by connecting theC-5210Power Adapter Harnessto the power distribution panel inside the machine.

    1. 120vac: Connect the blue wire to L1 and the brown wire to N.

    2. 240vac: Connect the blue wire to L1 and the brown wire to L2.

    3. Connect the green wire to ground.

  2. Connect the opposite end of theC-5210Power Adapter Harnessto theC-5602R1Power Converter.

  3. Connect theC-5500Power Extension Harness to the appropriate connector on theC-5602R1Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID1007
KitDescElectronic and Optical
  1. Disconnect the coin drop 6-pin connection from the machine.
  2. Connect the C-6373 Coin Sense Harness to the coin drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID1008
KitDescPulse
  1. Connect the C-5374 Machine Start Harness to the CN6 6-pin connector used for the coin drop.

Connect and Mount Reader

  1. Feed remaining harness ends through the mounting hole as described in the Touchscreen Reader Mounting Guide (F2 & F3).
  2. Connect the free end of the C-5374 Machine Start Harness to port 5 (Pulse Connection Port) as shown in the image above.
  3. Connect the free end of the C-6373 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.
  5. Secure the FasCard reader to base as described in the Touchscreen Reader Mounting Guide (F2 & F3).
Cci readerinstall footer