Versions Compared

Old Version 2

changes.mady.by.user Chris Kite

Saved on

compared with

New Version 3

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID980
KitDescSurface Mount

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID985
KitDescPayment Device Bay

  1. Optional: Remove existing payment device and cover opening usingC-0939BNA Cover Plate.

  2. Place theC-6700-TEMPDrill Template on the desired mounting location.

    1. IfC-0939 BNA Cover Plateis used, drilling mounting holes into the plate is recommended if able.

  3. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  4. Refer to for further instructions.

Connect Power

Power is supplied through the same Machine Interface Harnessdescribed in step 4.

Connect Coin Sense Harness

Not applicable in this setup. FasCard reader does not collect payment from any other devices, and will only send funds to the machine's control.

Connect Machine Interface Harness

Cci readerinstall kit
KitID839
KitDescSerial
  1. Connect theC-6124-MDB Machine Start Harness to the MDB interface harness on the Machine Control Assembly.
    1. Optional: Use the pigtail MDB connector to reconnect any existing payment devices.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the black, 10-pin connection of the C-6124-MDB Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. Connect the clear, 3-pin connection of theC-6124-MDB Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.
  4. Secure the FasCard reader to base as described in the Touchscreen Reader Mounting Guide (F2 & F3).
Cci readerinstall footer