Page Comparison

Place the C-5700-TEMP Drill Template on the desired mounting location.

Verify included harnesses will reach desired location without encountering interference from internal machine components.

Refer to the F1 FasCard Mounting Guide for further instructions.

Remove existing W11034287 Fascia from machine console panel. Remove the coin drop and coin box from the machine.

Insert C-6982 MayTag Adapter Bracket into the coin drop opening and align behind the coin drop bracket so the larger hole is towards the bottom. Then use (2) C-5420 10-32 x 1/4" Pan Screws to secure to the machine.

Install the W11034310 Fascia over the console panel.

Align the C-5414 F2 Standard Mounting Bracket with the holes in the C-6982 MayTag Adapter Bracket and attach together using (2) C-5436 10-32 x 1" Pan Screws.

Remove any cover or card reader plate attached to the payment device mounting bracket.

Place the C-5701 Mounting Plate behind the payment device mounting bracket and align the set of lower mounting points with that of the out set of threaded holes on the C-5701 Mounting Plate. Ensure the inner set of threaded holes are accessible through the central opening in the MayTag payment device bracket. Attach using (2) C-1060 8-32 x 3/8" Screws.

Place the C-5700 Mounting Bracket over the front of the assembly so that the set of circular openings align with the threaded holes of the C-5701 Mounting Plate accessible through the central opening. Attach using the remaining (2) C-1060 8-32 x 3/8" Screws.

Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5210 Power Adapter Harness to the power distribution panel inside the machine.

1. 120vac: Connect the blue wire to L1 and the brown wire to N.

2. 240vac: Connect the blue wire to L1 and the brown wire to L2.

3. Connect the green wire to ground.

Connect the opposite end of the C-5210 Power Adapter Harness to the C-5602R1 Power Converter.

Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602R1 Power Converter. The remaining cable end connects to the FasCard reader.

Connect the C-5364 Machine Start Harness to the AA3 connector on the Machine Control Assembly.