Versions Compared

Old Version 7

changes.mady.by.user Chris Kite

Saved on

compared with

New Version 8

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Remove coin drops and coin boxes.

  • Remove vault service switch connections from the switch and bridge using the C-5365 Bypass Harness.

  • Take the C-0940 Vault Cover and bend the inner tabs outward.

  • Insert the C-0940 Vault Cover into the coin box opening. The previously bent tabs should catch the inner lip of the coin vault and secure the bracket in place.

  • Place the C-5700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    1. Suggested mounting location: Coin drop opening.

    • Refer to FasCard Mounting Guide for further instructions.
    Cci readerinstall kit
    KitID906
    KitDescCard Only - All Card Models

    1. Place the C-6700-TEMP Drill Template on the desired mounting location.

    2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

    3. Refer to FasCard Mounting Guide for further instructions.

    Cci readerinstall kit
    KitID910
    KitDescCard Only - Flat Front Panel Coin Models

    Connect Power

    Cci readerinstall kit
    KitID581
    KitDescACA Controls

    1. Connect the C-6204-40 12VDC Power Harness to the H10 Connection on the Machine Control Assembly.

    2. Connect the green wire to a chassis ground.

    3. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

    ...