Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version 4

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID584
KitDescCoin and Card

  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to F2 FasCard Reader Mounting Guide for further instructions.

  • Remove existing coin box.

    • Remove Vault Switchand bridge the wires previously connected to the Vault Switchwith the C-5365 Bypass Harness.Bend the side tabs of theC-6936Vault Bracketoutward and install into the coin vault. The tabs should snap into place securing the bracket.Secure the C-5414 Standard Mounting Bracket to the C-6936Vault Bracket with C-0144 Screws.
    Cci readerinstall kit
    KitID856
    KitDescCard Only - Coin Ready Models
    Cci readerinstall kit
    KitID865
    KitDescCard Only - Card Ready Models

    1. Install the C-6970 Alliance Mounting Bracket into the opening on the control panel for mounting card readers and coin drops.

    2. Attach the C-5414 F2 Mounting Bracketto the C-6970 Alliance Mounting Bracket and secure using the C-1060 Screws.

    3. Refer to F2 FasCard Reader Mounting Guide for further instructions.

    Connect Power

    Cci readerinstall kit
    KitID581

    1. Connect the C-6204-40 Power Adapter Harness (12VDC power) to the H10 connection on the Machine Control Assembly.

      1. Secure the green wire beneath the ground screw.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID700
    KitDescCoin Drop: Factory

    1. Disconnect the coin drop from the machine control assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the coin drop.

    Cci readerinstall kit
    KitID928
    KitDescCoin Drop: Factory - Dual Coin

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 1 Drop.

    3. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 2 Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID582
    KitDescPulse and Serial

    1. Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. If using a dual coin drop, connect the second C-6250 Coin Sense Harness to port 4 (Coin 2 Sense Harness Connection Port) as shown in the image above.

    ...

    Cci readerinstall step
    componentReader

    Machine Configuration

    ACA machines using a serial configuration require dip switch 3 on the Machine Control Board to be set to the 'ON' position. Leave all other dip switches as is.

    ...