Versions Compared

Version Old Version 3 New Version 4
Changes made by

CCI Integration User

Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    Cci readerinstall kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID940
    KitDescCard Only - Coin Model

    1. Remove existing coin box and coin drop.

    2. Install the C-0913 Drop Cover in the coin drop opening and secure using the C-1062 Keps Nuts.

    3. Run all reader harnesses through coin vault and then the hole of the C-6936 Vault Bracket.

    4. Bend the side tabs of the C-6936 Vault Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

    5. Run all reader harnesses through the central hole of the C-5414 Reader Bracket.

    6. Attach the C-5414 Reader Bracket to the C-6936 Vault Bracketusing the C-0144 screw so that it is flush with the front panel.

    Cci readerinstall kit
    KitID995
    KitDescCard Only - Card Model

    1. Remove factory card reader interface bracket.

    2. Attach C-5414 Reader Bracket to the C-6918 Mounting Bracket using (2) C-5420 10-32 x 1/4" Pan Screw.
    3. Install the C-6918 Mounting Bracket in the payment device opening and secure using the (2) C-1062 Keps Nuts.
    4. Run all reader harnesses through the center hole in the C-6918 Mounting Bracket.

    Connect Power

    Cci readerinstall kit
    KitID595
    KitDescTap Machine Power

    1. Use the C-5101 Spade Taps on the incoming power.

      1. Tap the L1 wire.

      2. Tap the N / L2 wire.

      3. Tap the Ground wire.

    2. Take the C-5210 Power Adapter Harness and connect the red tab connectors to the following wires:

      1. Connect the blue wire to the L1 wire.

      2. Connect the brown wire to the N / L2 wire.

      3. Connect the green/yellow wire to the Ground wire.

    3. Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connection on the C-5602R1 Power Converter.

    4. Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connection on the C-5500 Power Extension Harness.

    Connect Coin Sense Harness

    cci-readerinstall-kitstep
    KitID721
    KitDescFactory Coin Drop
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6362 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    componentStart

    Connect the C-5370 Machine Start Harness to the 8-pin J6 harness connection accessible near the coin drop.
    cci-readerinstall-kit
    KitID997
    KitDescPulse - AA3/Debit Connection

    Connect and Mount Reader

    ...

    step
    componentReader

    Machine Configuration

    1. Enter Service Mode and navigate to J option.

    2. Set option to J.d.

    3. Exit Service Mode.

    Cci readerinstall footer