Versions Compared

Version Old Version 3 New Version 4
Changes made by

CCI Integration User

Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID584
KitDescCoin and Card

  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to FasCard Mounting Guide for further instructions.

Cci readerinstall kit
KitID863
KitDescCard Only

Coin Ready

  1. Remove existing coin box.

  2. Bend the side tabs of the C-6602 Vault Mount Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

  3. Use the C-0144 Screws, attach the C-5414 F2 Mounting Bracket to the C-6602 Vault Mount

Bracket
Cci readerinstall kit
KitID865
KitDescCard Ready
Install the C-6970

  1. Bracket

on the control panel.

  • Attach the C-5414 F2 Mounting Bracket onto the C-6970 Bracket using the C-1060 screws.

    • Connect Power

    Cci readerinstall kit
    KitID581

    1. Connect the C-6204-40 12VDC Power Harness to the H10 connection on the machine control assembly.

      1. Secure the green wire beneath the ground screw.

    2. Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) to the F2 reader.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID700
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Cci readerinstall kit
    KitID928
    KitDescCoin Drop: Factory - Dual Coin

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 1 Drop.

    3. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 2 Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID645
    KitDescPulse

    1. Connect the C-5300-NC Machine Start Harness to the Machine Control Assembly.

    Cci readerinstall kit
    KitID582
    KitDescSerial

    1. Connect the C-5240 Machine Start Harness to the Machine Control Assembly.

    For Card only

    1. Connect the C-5365 Bypass Harness to the appropriate connections to bypass the coin vault switch. **Needs Better Verbiage)

    Connect and Mount Reader

    ...

    cci-readerinstall-

    ...

    step

    ...

    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    componentReader

    Machine Configuration

    ACA machines using a serial configuration require dip switch 3 on the Machine Control Board to be set to the 'ON' position. Leave all other dip switches as is.

    ...