Page Comparison

Remove existing coin box and coin drop/slide.

Remove vault service switch connections from the switch and bridge using the C-5365 Bypass Harness.

Install C-5765-W Vault Bracket over the metercase opening. Secure in place using C-1059 Kep Nuts and C-1070-W Washers.

1. If installing on a coin slide equipped model the two holes next to the coin slide bolt will need to be enlarged about a 1/4" to allow the mounting studs to pass through the metercase.

Apply C-5027 Label on or near the reader if required for location.

Remove existing coin box and coin drop.

Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.

Attach the C-5414 F2 Mounting Bracket to the C-6765-W-R1 Metercase Bracket using C-5702 Chase Nipple and C-5703 Lock Nut.

Run any card reader harnesses through the coin slot openings and the circular hole in the C-6765-W-R1 Metercase Bracket.

Install the C-6765-W-R1 Metercase Bracket so that the two threaded posts insert into the coin drop slots. Then secure it to the machine using the C-1059 Kep Nuts and C-1070-W Washers.

Place the C-6700-TEMP Drill Template on the desired mounting location.

Verify included harnesses will reach desired location without encountering interference from internal machine components.

Refer to FasCard Mounting Guide for further instructions.