Page Comparison

Place the C-6700-TEMP Drill Template on the desired mounting location.

Verify included harnesses will reach desired location without encountering interference from internal machine components.

Refer to F2 Mounting Guide for further instructions.

Optional: Apply C-5033 Label over coin drop opening.

Use the C-5101 Spade Taps on the incoming power.

1. Tap the L1 wire.

2. Tap the N wire.

3. Tap the Ground wire.

Take the C-5210 Power Adapter Harness and connect the red tab connectors to the following wires:

1. Connect the blue wire to the L1 wire.

2. Connect the brown wire to the N wire.

3. Connect the green/yellow wire to the Ground wire.

Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connection on the C-5602R1 Power Converter.

Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connection on the C-5500-60 Power Extension Harness.