Place the C-6700-TEMPDrill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to
for further instructions.
Cci readerinstall kit
KitID
872
KitDesc
Card Only
Install the C-0961Jam Ring into the coin vault. TheJam Ringshould be installed into the coin vault so that it is within 1.5" of front panel of the machine to allow the mounting bracket to be attached.To install theJam Ringinsert the ring so the small portion is on the bottom. Insert at an angle, so the top of theJam Ringis inserted first. Once the ring is in position, pull the top of theJam Ringtowards the front of the machine until it locks into place.Using theC-5751Screws, attach theC-6960Mounting Bracketto theC-0961Jam Ring.Attach the C-5414 Standard Mounting Bracketto the C-6960 Mounting Bracketusing the C-5420 Screws.
FasCard Mounting Guide for further instructions.
Connect Power
Cci readerinstall kit
KitID
595
Tap power as described in the Fascard Reader Install - Universal Conceptsdocument using the C-5101Spade Taps provided.
Connect the C-5210Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602Power Converter.
Connect the C-5500Power Extension Harness to the appropriate connector on the C-5602Power Converter. The remaining cable end connects to the FasCard reader.
Connect Coin Sense Harness
Cci readerinstall kit
KitID
704
KitDesc
Coin Drop: Factory
Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-6253Coin Sense Harness to the harness connected to the Coin Drop.
Connect Machine Interface Harness
Cci readerinstall kit
KitID
636
KitDesc
Pulse
Connect the C-5256Machine Start Harness to the Coin 1 connector on the Machine Control Assembly.