Place the C-6700-TEMPDrill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to
for further instructions.
Cci readerinstall kit
KitID
982
KitDesc
Card Only
Disconnect wires connected to vault service switch and bridge connection using C-5365 Bypass Harness.
Remove the front control Panel and pull panel away from machine exposing the factory plate / Coin Drop
Loosen the two (2) left retaining screws (Green) and remove the remaining screws on the bracket (Blue) and slide the bracket off the machine. Slide the C-6965QTMounting Bracket onto the loose screws and tighten. Add remaining screws to the corresponding holes on the bracket and tighten.
Re-secure the front panel to the machine.
Attach the C-5414 Reader Bracket to the C-6965 QTMounting Bracket using C-5702 Chase Nipple and C-5703 Nut. Feed all reader harnesses through the center hole
Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.
Connect Power
Cci readerinstall kit
KitID
581
Connect the C-6204-40 Power Adapter Harness to the H10 connection on the machine control board.
Secure the green wire beneath the ground screw.
Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) into the back of the F1 Reader.
Connect Coin Sense Harness
Cci readerinstall kit
KitID
700
KitDesc
Coin Drop: Factory
Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.
Connect Machine Interface Harness
Cci readerinstall kit
KitID
582
KitDesc
Serial or Pulse
Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.