Page Comparison

Remove existing coin drop.

Install C-0913 Drop Cover where the coin drop was previously installed. Secure in place with C-1062 Kep Nuts.

Place the C-6700-TEMP Drill Template on the desired mounting location.

Verify included harnesses will reach desired location without encountering interference from internal machine components.

Refer to FasCard Mounting Guide for further instructions.

Tap the machine AC power wires using the C-5101 Spade Taps.

1. For 120v models: L1, N, and Ground wires

2. For 240v models: L1, L2, and Ground wires

Connect the three wires from the C-5210 Power Adapter Harness to theC-5101 Spade Taps.

1. Connect the Blue wire to the L1 tap.

2. Connect the Brown wire to the N/L2 tap.

3. Connect the Green/Yellow wire to the Ground tap.

Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connector on the C-5602R1 Power Converter.

Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500-60 Power Extension Harness.

Run the C-5500-60 Power Extension Harness to the reader mounting location.