Versions Compared

Version Old Version 4 New Version 5
Changes made by

Chris Kite

Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Install Mounting Hardware

for further instructions.

  • Place the C-5700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide
    Cci readerinstall kit
    Cci readerinstall kit
    KitID616
    KitDescCoin and Card
    Cci readerinstall kit
    KitID841
    KitDescCoin and Card
    KitID966
    KitDescCard Only

    1. Apply C-5035 Label over the coin drop opening.

    2. Place the C-6700-TEMP Drill Template on the desired mounting location.

    3. Verify included harnesses will reach desired location without encountering interference from internal machine components.

    4. Refer to FasCard Mounting Guide for further instructions.

    Connect Power

    ...

    KitID595

    ...

    Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.

    ...

    Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID695
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-5368 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    KitID722
    KitDescCoin Drop: Factory

    ...

    Connect

    ...

    Coin Sense Harness

    ...

    Connect Machine Interface Harness

    ...

    KitID653
    KitDescPulse

    ...

    Harness

    ...

    Connect and Mount Reader

    ...

    Reader

    ...

    Item No.

    Component

    Notes

    1

    Power Connection Port

    Utilizes the same power harnesses as the first generation FasCard reader.

    2

    Pulse Connection Port

    Connection point for pulse machine start harnesses.

    3

    Coin 1 Connection Port

    This is the connection point for the harness input associated with Coin 1.

    4

    Coin 2 Connection Port

    This is the connection point for the harness input associated with Coin 2.

    5

    Serial Connection Port

    This is the connection point for serial machine start harnesses.

    1. Feed remaining harness ends through the mounting hole as described in the F2,F3 Reader Install Guide.

    2. Connect the free end of the C-5345 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.

    3. Connect the free end of the C-6368 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.

    4. Connect the free end of the C-5500 Power Harness to port 1.

    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    Cci readerinstall footer