...
| Cci readerinstall kit |
|---|
| KitID | 906 |
|---|
| KitDesc | Card Only - Rear Control Card Models |
|---|
|
Place C-5763 TWL Bracket in the intended mounting location. Using the bracket, mark the location of all four mounting holes.
Drill a hole at each marked location using a 3/16" drill bit.
Attach C-5414 Mounting Bracket to the front of C-5763 using two C-5420 screws.
Mount the C-5763 TLW Bracket using four C-5420 Screws and fasten from the inside of the panel.
|
| Cci readerinstall kit |
|---|
| Cci readerinstall kit |
|---|
| KitID | 791 |
|---|
| KitDesc | Card Only - 10 Degree Front Panel Coin Drop Models |
|---|
|
Remove existing coin box and coin drop. Remove connections to coin vault service switch and bridge connections using C-5365 Bypass Harness. Install C-5765-W Metercase Bracket over the front of the metercase and secure using the C-1059 Kep Nut, and C-1070-W Washer.
|
| KitID | 857 |
|---|
| KitDesc | Card Only - 10° Panel Coin Model |
|---|
|
| Cci readerinstall kit |
|---|
| KitID | 595 |
|---|
| KitDesc | Coin Slide Models - Tap 120/240v Power |
|---|
|
Remove existing coin box and coin drop. Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness. Attach the C-5414 F2 Mounting Bracket to the C-6765-W-R1 Metercase Bracket using (2) C-5420 10-32 x 1/4 Pan Screws. Run any card reader harnesses through the coin slot openings and the circular hole in the C-6765-W-R1Metercase Bracket.
|
Use the C-5101 Spade Taps on the incoming power. Tap the L1 wire. Install the C-6765-W-R1 Metercase Bracket so that the two threaded posts insert into the coin drop slots. Then secure it to the machine using the (2) C-1059 Kep Nuts and (2) C-1070-W Washers.
|
Connect Power
. Tap the Ground wire. Take the C-5210 Power Adapter Harness and connect the red tab connectors to the following wires: Connect the blue wire to the L1 wire.
|
Connect
...
Connect the green/yellow wire to the Ground wire.
...
Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connection on the C-5602R1 Power Converter.
...
Power
...
| Cci readerinstall kit |
|---|
| KitID | 581 |
|---|
| KitDesc | ACA Controls - 12VDC Accessory Power |
|---|
|
Connect the C-6204-40 12VDC Power Harness to the H10 connection on the machine control assembly. Secure the green wire beneath the ground screw.
Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) to the F2 reader.
|
...