Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID584
KitDescCoin and Card
  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to

for further instructions.
Cci readerinstall kit
KitID1033
KitDescCard Only - Coin Model
Feed all reader harness ends through the open face of theCoin Vault.Spread theC-6602 Vault Mount Bracketwings outward.Feed the harness ends through theC-6602Vault Mount Bracket.Insert theC-6602Vault Mount Bracketinto theCoin Vaultand ensure the inner tabs lock into place so it's secured in place.Feed the remaining harness ends through both theC-6601Filler PlateandC-5414F2 Mounting Bracket.Secure both the C-5414 F2 Mounting Bracket and C-6601 Filler Plate to theC-6602 Vault Mount Bracket with theC-0144 Screws
  1. FasCard Mounting Guide for further instructions.

Connect Power

Cci readerinstall kit
KitID794
KitDescTap Source Machine Power
  1. Tap the machine AC power wires using the C-5101 Spade Taps.

    1. For 120v models: L1, N, and Ground wires

    2. For 240v models: L1, L2, and Ground wires

  2. Connect the three wires from the C-5210 Power Adapter Harness to theC-5101 Spade Taps.

    1. Connect the Blue wire to the L1 tap.

    2. Connect the Brown wire to the N/L2 tap.

    3. Connect the Green/Yellow wire to the Ground tap.

  3. Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connector on the C-5602R1 Power Converter.

  4. Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500-84 Power Extension Harness.

  5. Run the C-5500-84 Power Extension Harness to the reader mounting location.

Connect Coin Sense Harness

Cci readerinstall kit
KitID719
KitDescCoin Drop - Factory Optical
  1. Disconnect coin drop from factory machine harness.

  2. Connect C-6360 Coin Sense Harness to the coin drop.

    1. Connect red to red.

    2. Connect green to brown.

    3. Connect blue to blue.

Connect Machine Interface Harness

Cci readerinstall kit
KitID636
KitDescPulse - Coin Connection
  1. Connect the C-5256 Machine Start Harness to the harness originally connected to the coin drop.

    1. Connect to the black and brown wires.

    2. To prevent any potential electrical issues, apply electrical tape over the blue wire connector.

Connect and Mount Reader

...

Reader

...

Cci readerinstall footer