Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID584
KitDescCoin and Card
  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to

for further instructions.
Cci readerinstall kit
KitID872
KitDescCard Only
Install the C-0961 Jam Ring into the coin vault. TheJam Ring should be installed into the coin vault so that it is within 1.5" of front panel of the machine to allow the mounting bracket to be attached.To install theJam Ring insert the ring so the small portion is on the bottom. Insert at an angle, so the top of theJam Ring is inserted first. Once the ring is in position, pull the top of theJam Ring towards the front of the machine until it locks into place.
  • Using the C-5751 Screws, attach the C-6960 Mounting Bracket to the C-0961 Jam Ring.
  • Attach the C-5414 Standard Mounting Bracketto the C-6960 Mounting Bracketusing the C-5420 Screws.
    1. FasCard Mounting Guide for further instructions.

    Connect Power

    Cci readerinstall kit
    KitID802
    1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

    2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.

    3. Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID704
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID636
    KitDescPulse
    1. Connect the C-5256 Machine Start Harness to the harness that was previously connected to the Coin Drop.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Machine Configuration

    TODO

    ...