Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version 4

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID841
KitDescCoin and Card

  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to

for further instructions.
Cci readerinstall kit
KitID842
KitDescCard Only

  • Remove existing coin box and drop.

  • Mount C-0905 Drop Cover where the coin drop was originally installed. Use factory hardware to secure.
  • Run all reader harnesses through the center hole of the C-6936 Vault Bracket.
    1. Optional: Attach C-5710 Rubber Grommet to center hole of bracket to reduce abrasion of wiring during machine operation.

  • Bend the side tabs of the C-6936 Vault Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

    • Attach the C-5414 Reader Bracket to the C-6936 Vault Bracket using the C-0144 Screws

    1. Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.

    Connect Power

    Cci readerinstall kit
    KitID805

    1. Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5211 Power Adapter Harness to the power distribution panel inside the machine.

      1. 120vac: Connect the brown and blue wires to connector #2 closest to outside of machine and #4 on terminal side closest to circuit board.

      2. 240vac: Connect the brown and blue wires to connectors 3 and 5 on the terminal side closest to the circuit board.

      3. Secure the green wire beneath the ground screw.

    2. Connect the opposite end of the C-5211 Power Adapter Harness to the C-5602 Power Converter.

    3. Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID704
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6253 Coin Sense Harness to the microswitch on to the Coin Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID634
    KitDescPulse

    1. Connect the C-5254 Machine Start Harness to the P2 connector on the Machine Control Assembly.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the Touchscreen Reader Mounting Guide (F2 & F3).
    2. Connect the free end of the C-5254 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500-60 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the Touchscreen Reader Mounting Guide (F2 & F3).

    Machine Configuration

    ...

    Cci readerinstall footer