...
Install Mounting Hardware
...
| KitID | 584 |
|---|---|
| KitDesc | Coin and Card |
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
| KitID | 959 |
|---|---|
| KitDesc | Card Only |
...
Remove existing coin drop.
...
Install C-0913 Drop Cover where the coin drop was previously installed. Secure in place with C-1062 Kep Nuts.
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
Connect Power
...
Power
...
For 120v models: L1, N, and Ground wires
For 240v models: L1, L2, and Ground wires
...
Connect the Blue wire to the L1 tap.
Connect the Brown wire to the N/L2 tap.
Connect the Green/Yellow wire to the Ground tap.
Connect
...
Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500-60 Power Extension Harness.
...
Run the C-5500-60 Power Extension Harness to the reader mounting location.
Connect Coin Sense Harness
...
| KitID | 722 |
|---|---|
| KitDesc | Factory - Optical Coin Drop |
...
Disconnect the Coin Drop from the Machine Control Assembly.
...
Connect Machine Interface Harness
...