...
Install Mounting Hardware
...
| KitID | 841 |
|---|---|
| KitDesc | Coin and Card Install |
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
| KitID | 959 |
|---|---|
| KitDesc | Card Only Install - Coin Model |
...
Remove existing coin drop.
...
Install C-0913 Drop Cover where the coin drop was previously mounted. Secure using (4) C-1062 4-40 Keps Nuts.
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify that included harnesses will reach the desired location without encountering interference from internal machine components.
...
Optional: Use C-5710 Rubber Grommet to protect harnesses from damage during machine operation if any secondary hole is cut internally to run harnesses to the reader mounting location.
Connect Power
...
| KitID | 802 |
|---|
...
Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
Connect
...
Power
...
Connect Coin Sense Harness
...
| KitID | 711 |
|---|
...
Disconnect the Coin Drop from the Machine Control Assembly.
...
...
| KitID | 722 |
|---|
...
Disconnect the Coin Drop from the Machine Control Assembly.
Connect
...
Coin Sense Harness
...
Connect Machine Interface Harness
...
| KitID | 653 |
|---|
...
Harness
...
Connect and Mount Reader
...
Feed remaining harness ends through the mounting hole as described in the FasCard F2/F3 Reader Installation Guide - Front Mount.
...
Connect the free end of the Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
...
Connect the free end of the Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
...
Connect the free end of the C-5500-60 Power Harness to port 1.
...
Reader
...
Machine Configuration
None required.
...