...
Install Mounting Hardware
...
| KitID | 584 |
|---|---|
| KitDesc | Coin and Card |
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
| KitID | 994 |
|---|---|
| KitDesc | Card Only |
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
Optional: Apply C-5033 Label over coin drop opening.
Connect Power
...
| KitID | 802 |
|---|---|
| KitDesc | Tap Machine Power |
...
Use the C-5101 Spade Taps on the incoming power.
Tap the L1 wire.
Tap the N wire.
Tap the Ground wire.
...
Take the C-5210 Power Adapter Harness and connect the red tab connectors to the following wires:
Connect the blue wire to the L1 wire.
Connect the brown wire to the N wire.
Connect the green/yellow wire to the Ground wire.
...
Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connection on the C-5602R1 Power Converter.
Connect
...
Power
...
...
| KitID | 722 |
|---|---|
| KitDesc | Factory Coin Drop |
...
Disconnect the Coin Drop from the Machine Control Assembly.
Connect
...
Coin Sense Harness
...
Connect Machine Interface Harness
...