Page Comparison

Step 3 – Connecting the bracket assembly

1. Attach the C-1024B assembly to the C-1024A bracket using the 2 set screws.

2. Tilt the C-1024B plate completely towards the card dispenser.

   Image RemovedImage Added

Step 4 – Aligning the barcode scanner

1. Slide the C-1024C bracket completely to the right, then rotate it clockwise so the silver connector at the top is pointing to about 2 minutes after midnight on the face of a clock (use image below for reference).

2. Screw in the scanner set screw located just to the left of the scanner and tighten slightly.

Step 5 – Final adjustments

1. Slowly adjust the scanner in millimeter increments by twisting the assembly clockwise while dispensing cards incrementally to test the adjustment.

2. Adjusting the scanner requires some trial and error as the multi-laser design of the scanner means there is no single perfect alignment.

   1. Pressing the “M” or Zebra logo button will allow the scanner to light up, assisting you in positioning the scanner correctly.

3. CCI recommends successfully dispensing 25-50 cards consecutively with no errors before tightening the set-screw and then testing another 25-50 cards with the door closed and locked.

rw-tabWelch Allyn installation guide

Expand
title Welch Allyn Scanner
groupIds	users
specialUsername	anonymous
matchUsing	any
Required hardware Bw part list Parts C-1010,C-1400-121 ImageSize 150 ShowImage true SingleRow true Step-by-step guide Step 1 – Installing the scanner The bard code scanner may be attached to the cabinet door with two stips of Velcro or by attaching the barcode reader to the C-1400-121 scanner plate and then attaching the plate to the cabinet. It is recommended that there be a 1 ½ to 2-inch space present between the scanner and the card dispenser tray. Image RemovedImage Added Image RemovedImage Added Step 2 – Aligning the scanner When mounted using Velcro, a small card or folded piece of cardboard could be wedged on the top of the barcode unit. When mouted using the scanner plate, two 8-32 philips screws can be inserted into the plate, forcing the scanner to lean backward. Image Removed
Hide if
Image Added Reset barcodes DO NOT perform these next steps unless conducted by CCI. These barcodes are used exclusively for the Motorola/Zebra barcode scanners. DO NOT use them on the Symbol type or any other type of scanner. Resetting the scanners Unplug the scanner cable. Plug the cable back in and wait for the beeping to stop. Scan the “Reset Defaults” barcode first. The scanner will reset and beep. Scan the “SNAPI” barcode next. The scanner should now be setup for the LaundryCard system. Reset Defaults barcode SNAPI setup barcode Image Added Image Added INI file settings Code Block [Valuestation1] BarcodeScanModel=MS4407

Related documents

Filter by label (Content by label)
showLabels false sort modified showSpace false reverse true cql label = "barcode-scanner" and space = currentSpace ( )