Panel | ||||
---|---|---|---|---|
| ||||
When using the C-1004-V2 MEI Talos Bill Note Acceptor (BNA) in a Touch Kiosk, a specific power cable is utilized separately from the Touch Kiosk's default Power Controller Bill Acceptor port. This detailed page provides information and method of installation for the C-5660-110P BNA Power Cable used. |
Panel | ||||
---|---|---|---|---|
| ||||
|
Warning | ||
---|---|---|
| ||
Disconnect any electrical device from power before performing any work on the device. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or any damage that may occur to target equipment. Technical Support recommends using all appropriate safety equipment (such as hand and eye protection) during execution of the instructions below. |
Introduction
Bw part list | ||
---|---|---|
|
Unlike the legacy C-5660 MEI BNA and C-5660-V2 MEI Talos BNA that utilize the 9-pin 24v port on the Power Controller, the C-1004-V2 MEI Talos BNA has a 110vac power requirement. The C-5660-110P BNA Power Cable is specifically designed to power the C-1004-V2 MEI Talos BNA within a Touch Kiosk by drawing power directly from the power supply's Load (L) and Neutral (N) terminals.
Installation
Table excerpt | ||
---|---|---|
| ||
|
Related
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|