Versions Compared

Old Version 5

changes.mady.by.user Former user

Saved on

compared with

New Version 6

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Div
Classtoc-header
Section
Column
width30
Panel
borderColor#981A28
titleColor#FFFFFF
titleBGColor#981A28
titleTable of Contents

Table of Contents
maxLevel3

Column
width70
Panel
borderColor#981A28
titleColor#FFFFFF
titleBGColor#981A28
titleOverview

 This document is intended to guide the user through removal of the standard LaundryCard reader bezel and installation of a flat-mount bezel.

 

Required Hardware

Multiexcerpt include
MultiExcerptNameInstall Header
PageWithExcerptCCIDOC:_LC Reader Installation

Additional Hardware

Bw part list
PartsC-0968
ShowDesc2false
ShowDesc3false

The completion of this guide requires a flat mount bezel similar to the one listed above.  Actual bezel may vary- consult appropriate kit information or contact Technical Support for individual part information.

Required Tools and Supplies (Not Included)

  • Needle nose pliers
  • Phillips head screw driver

Installation

Panel
bgColor#981A28

Step 1 - Remove Existing Bezel

  1. Remove any existing label surrounding the card slot on the card reader, if necessary.
  2. Remove the four screws securing the plastic grey bezel to the LaundryCard reader.
    1. Two screws are located above the card slot and two are located below.
    2. Retain screws for flat mount bezel install.
  3. Gently remove the plastic bezel.
Panel
bgColor#981A28

Step 2 - Attach the Flat Mount Bezel

  1. Place the LaundryCard reader assembly against the flat mount bezel and secure with four screws retained in step 1.
  2. Using needle nose pliers, gently bend the bracket holding the card reader screen until it lies flush against the upper slot in the flat mount bezel.
    1. Use caution as card reader circuitry and LCD screens are fragile.
  3. Once LaundryCard reader is satisfactorily secured and positioned, flat mount bezel may be mounted on appropriate machine facing using the materials provided in the associated kit.