Content Comparison

1. Step 1 part 1

1. Remove the side panel from the PC by sliding the lock release (top of case) toward the rear of the case.
2. Press the blue tabs (highlighted above) on the hard drive enclosure.
3. Lift hard drive enclosure free.

1. Step 2 part 1

1. Hold down the blue tab next to the optical drive (highlighted above).
2. Slide the optical drive toward the rear of the case and lift it away.

1. Step 3 part 1

1. Locate the existing memory in the appropriate slots.
2. Press down on the tabs at each end of the memory slot. This will cause the existing memory to lift slightly from the slot.
   1. Remove both memory boards in this fashion.

Image Added

1. Step 4 part 1Install new memory boards in the slots with the white tabs.
   1. This should correspond to the slots from which the existing memory was removed in Step 3.
   2. Memory boards are notched and will only fit into the slot in one direction. Do not force.
2. Once memory is seated in the slot, press down gently but firmly until the white tabs lock into place.

1. Step 5 part 1.

1. Re-seat the optical drive by sliding it forward into the slot from which it was removed while depressing the blue tab highlighted in Step 2.
   1. Optical drive should lock into place when the blue tab is released.
2. Re-seat the hard drive enclosure in its original position.
   1. Tabs at the rear of the enclosure fit into the slots highlighted in the image above.
   2. Enclosure should lock into place when seated properly.