Page Comparison

Equipment Models

This document is valid for Alliance machines using the A-Micro control.

Instructions

1. Make sure your card reader is connected to the washer and setup in the LaundryCard software correctly
2. Toggle switch on washer computer to enter program mode
3. Display will read TSFL
4. Press Asterisk button (Quick Wash Warm)
5. Press green (Start) button repeatedly until washer display TSFL again
6. Toggle switch back  of washer computer to set back to run mode
7. Check if card reader updates pricing on washer. If so test start the washer.
   
   1. If display of washer is NOT updating the price power cycle the washer
   2. If pricing still does not update you may need to reset WCRD.
      Easiest way to do this is: 
      
      1. Insert manager card into X-Changer
      2. Press Manager
      3. Press Equip Setup
      4. Press Config (Agree to the alert)
      5. When Config page loads press on the Done button
      6. Readers in store should refresh and washer should now be talking to reader.

Step-by-step guide

Step by step to convert Huebsch HCxxAC2 or HCxxACV Micro machines to card ready machines

 Change pricing to 1pr and set vend to 1.50 and extra wash and rinse to .25 by the following steps.

1. With original coin chip installed flip program switch to the left to program mode "tSFL" appears on screen.
2. Press "rugs/blanket Cold" button which has * printed on it.
3. Display will show model and size example "HC20_"  for 20# machine.
4. Press Start Display reads "nOd1" for one second then displays extra wash add cost.
5. Use "extra Wash" for increase   "extra rinse" for decrease to .25 then press "start"
6. "nOd2" is displayed for one second then displays extra rinse add cost.
7. Use "extra Wash" for increase   "extra rinse" for decrease to .25 then press "start"
8. Use Start key to advance past  programming steps:
   "Far"
   "nOHt"
   "nEFL"
9. Next step needs to be set to "1Pr"  using the Extra Wash to toggle from "6Pr"
10. Next change Value "AntStrt" to  $1.50 using Extra Wash key for increase or Extra Rinse key for decrease hit start key until "tSFL"  appears then flip program switch back to run mode.
11. Check that all 6 cycles are 1.50 and extra wash is .25 and Extra rinse is .25
12. Cut power off from machine.
13. Install Card Chip with half circle marking in correct orientation with chip socket on main board
    For the “AC2” (2-Speed) Control, you would need to order P/N F8228701, to make it a “AY2”.
    For the “ACV” (V- Speed) Control, you would need to order P/N F8228702, to make it a “AYV”.
14. Install Daughter board F200017400P onto left side of control lining up the black female socket with the pins on control and tighten the 2 nuts to secure.
15. Install card reader and harnesses per instructions
16. Power on machine.
17. After dashes clear and correct price from Fascard reader is displayed on Washer display  flip  program switch to program side. “tSFL” appears on display.
18. Push "rugs/blanket Cold"  (*) key 
19. Push start key several times until "tSFL" appears again.
20. Flip program switch back to run mode and test start.