Card Reader Connection (Pulse/
...
Single-vend)
- Using the cabling diagram, locate the 1st machine number on the first line. Normally this will be Machine #1 and it will be the 1st machine on Line 0.
- Install the card reader into each machine using the following steps:
- Using a Pulse or “Single-Vend” harness, Connect the vend harness (provided in the mounting kit) to the card reader. The proper installation instruction should be included in the kit for each model of equipment. The install guides can also be found online at: wiki.laundrycard.com
- Each machine must be set to start for one pulse or “token” mode. The price on the machine should be suppressed or set to display $0.01 whenever possible to allow the best pricing experience and to avoid confusion from the customers. This must be done by the installer, CCI is not responsible for the programming of machines.
| Note | ||
|---|---|---|
| ||
NOTE: If the machine does not have a coin vault or card system mount, some machines will need to be modified to accommodate the readers. This includes cutting metal panels. This should be considered prior to installation. |
- Install the coin vault mounting bracket (provided in the mounting kit).
- If required, attach the threaded spacers to the mounting bracket.
- Feed the reader end of the vend harness, along with the data cable, through the coin vault opening and through the mounting bracket. Connect the harness and the data cable to the card reader.
- Feed the other data cable through the coin vault opening and through the mounting bracket. Then connect the data cable to the card reader's left port. Mount the reader to the mounting bracket. Do not over tighten the mounting screws!
- Install the coin drop or coin vault cover plate if provided in the installation kit.
- Move on to the next machine and repeat steps throughout the store until all equipment are connected to readers.
...