Versions Compared

Old Version 12

changes.mady.by.user Former user

Saved on

compared with

New Version 13

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of Contents

Table of Contents
excludeTable of Contents

Equipment Models

This document is valid for the following equipment models...

  • C-5001 FasCard Reader

Assumptions

This document assumes the installer has already configured a machine type via the FasCard administration website. For more information see 'Configuring Machine Types'

Tools Required

  • No tools are required
Div
Classtoc-header
Section
Column
width30
Panel
titleOn this Page

Table of Contents
maxLevel2
minLevel2

Column
width70
Panel
titleOverview

This page is intended to guide the user through the process of addressing FasCard F1 and F2 readers.

For assistance in determining the generation of the reader to be addressed, refer to Determining CCI System and Version Information.

Ui tabs
Ui tab
titleF1 Reader Addressing Instructions

F1 Reader Addressing Instructions 

Access 'Set Address' Mode with Power Up Method

FasCard readers can be addressed during their initial start up routine.

  1. Connect power to FasCard reader
  2. Immediately after the card reader version appears, press

...

  1. and hold all three buttons for a moment.
  2. Manager menu appears
  3. Navigate to Maintenance menu and press - key

Access 'Set Address' Mode with Machine Admin Card

FasCard readers can be addressed anytime with a FasCard with the appropriate privileges asigned.

  1. Swipe FasCard with Machine Admin privleges
  2. Menu Appears
  3. Using arrows on keypad highlight 'Maintenance Menu' and press the - key

Setting Address

  1. The 'Change Machine#' option should be highlighted, press the - key
  2. Set Machine Number appears with 3 digits appearing the first one blinking
  3. Use the up and down arrows to change the flashing digit to the desired value
  4. Use the - key to confirm selection and move to the next digit
  5. Once all three digits have the desired values, the newly set number will be displayed and 'Confirm' will be flashing
    1. Press - to confirm
    2. Press any other key to display 'Retry', press - to re-enter address
Ui tab
titleF2 Reader Addressing Instructions

F2 Reader Addressing Instructions 

Access the 'Set Address Mode' using one of the two methods presented below.

The F2 FasCard reader maintenance menu can be accessed in the following ways:

Method 1

  1. Swipe a Manager's card or any card with System Maintenance privileges.
  2. Touch the "Maintenance Menu" button on the touchscreen.
  3. Touch "Change Machine #" on the touchscreen.

Method 2

  1. Reboot the card reader- after the FasCard logo disappears and the pricing information is shown, press and hold anywhere on the touchscreen.
  2. Touch the "Maintenance Menu" button on the touchscreen.
  3. Touch "Change Machine #" on the touchscreen.

The following screen will appear:

  • Digits will change from left to right as a number is touched.
  • Press the back arrow to move from right to left for error correction.
  • Press "Save" once all three digits are entered.

Additional Information