...
| Ui text box | ||
|---|---|---|
| ||
Connection points for the F2 FasCard reader may be found on the F2: Touch Screen FasCard Touchscreen Reader page. |
- Connecting the opposite end of the harness varies by board type, but in general a Single-vend/Pulse connection will connect where the coin drop was previously connected. Multi-vend/Serial connections typically connect to a specific serial port on the board, which will also vary by machine.
- Connecting a coin drop may require a coin sense harness to adapt the native connection. This will be included in your installation kit if needed (see Fig. 2b, above).
- Connecting the power supply utilizes a harness provided with your reader. Power considerations are further discussed below under the heading "Tapping Power".
...
An example of a Single-vend harness is shown below in Fig. 3a and an example of Single-vend configuration page is shown in Fig. 3b.
- A single-vend harness will always connect to the FasCard reader on the connection labeled "C" in Figure 2a, above.
- The board-side end of the harness will vary by machine/connection type.
- More information on Single-vend start methods and configurations is available here: Configuring SingleVend.
...