Versions Compared

Old Version 1

changes.mady.by.user David Bussman

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID917
KitDescCoin and Card

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID815
KitDescCard Only - 25lb & Smaller Models

  1. Remove existing coin box and coin drop.

  2. Install the C-0928 Vault Mounting Bracket over the coin vault. Secure in place using (2) C-1059 10-32 Kep Nuts.

  3. Optional: Apply the C-5027 Label for any credit card issuer accepted at the facility.
Cci readerinstall kit
KitID817
KitDescCard Only - 30lb & Larger Models

  1. Remove existing coin box and coin drop.

  2. Install the C-0934 Vault Mounting Bracket over the coin vault. Secure in place using (2) C-1059 10-32 Kep Nuts.

  3. Optional: Apply the C-5027 Label for any credit card issuer accepted at the facility.

Connect Power

Cci readerinstall kit
KitID595
KitDescTap Machine Source Power
  1. Tap power as described in the document using theC-5101 Spade Taps provided.
  2. Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.
  3. Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID689
KitDescCoin Drop: Factory
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect theC-5357 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID814
KitDescSerial - Compass Pro
  1. Connect theC-0126-MLVMachine Start Harness to the RS232connection on the Machine Control Assembly.
  2. Connect theC-5359Machine Start Harness to the Input 1connection on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF1 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of theC-5359 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the free end of the C-0126-MLV Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  4. (Coin and Card Installation Only) Connect the free end of the C-5357 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  5. Connect the free end of the C-5500 Power Extension Harness to port 4 (Power Harness Connection Port) as shown in the image above.
Cci readerinstall footer