Versions Compared

Old Version 1

changes.mady.by.user Brett Norrell

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID616
KitDescCoin and Card

  1. Place the C-5700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID822
KitDescCard Only - Card Ready

  1. Place theC-5700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

  4. If needed, use C-5633-R1 Labelto cover the factory card reader slot.

Connect Power

Cci readerinstall kit
KitID595
  1. Tap power as described in the document using theC-5101 Spade Taps provided.
  2. Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.
  3. Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID674
KitDescCoin Drop: Factory
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect the C-5250 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID642
KitDescPulse
  1. Connect theC-5257 Machine Start Harness to the Coin 1harness previously connected to the coin drop.
Cci readerinstall kit
KitID643
KitDescSerial
  1. Connect theC-5274R1Machine Start Harness to the Serialconnector on the communication harness.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF1 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole as described in theFasCard Mounting Guide.
  2. Connect the free end of the Machine Start Harness:
    1. For C-5272 pulse harness setups connect to port 2 (Pulse Connection Port) as shown in the image above.
    2. For C-5274R1 serial harness setups connect to port 1 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of theC-5250Coin Sense Harnessto port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of theC-5500Power Extension Harness to port 4 ( Power Harness Connection Port) as shown in the image above.
  5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

Machine Configuration

TODO

Cci readerinstall footer