Versions Compared

Old Version 11

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

cci-readerinstall-kit
KitID857
KitDescCard Only - 10° Panel Coin Models

  1. Remove existing coin box and coin drop.

  2. Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.

  3. Attach the C-5414 F2 Mounting Bracket to the C-6765-W-R1 Metercase Bracket using C-5702 Chase Nipple and C-5703 Lock Nut.

  4. Run any card reader harnesses through the coin slot openings and the circular hole in the C-6765-W-R1 Metercase Bracket.

  5. Install the C-6765-W-R1 Metercase Bracket so that the two threaded posts insert into the coin drop slots. Then secure it to the machine using the C-1059 Kep Nuts and C-1070-W Washers.

...

step
componentMounting

cci-readerinstall-kitstep
KitID581
KitDescACA Controls

  1. Connect the C-6204-40 12VDC Power Harness to the H10 Connection on the Machine Control Assembly.

  2. Connect the green wire to a chassis ground.

  3. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

...

componentPower

  • Disconnect the Coin Drop from the Machine Control Assembly.

    • Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kit
    KitID700
    KitDescFactory Standard Coin Drop
    step
    componentCoin Sense

    cci-readerinstall-kit
    KitID704
    KitDescFactory Standard Coin Slide

    1. Locate the micro switch on the coin slide assembly for the upper pocket.

    2. Disconnect the harness connected to the microswitch and connect C-6253 Coin Sense Harness to the spade tabs on the micro switch.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID645
    KitDescPulse - Coin Connection

    1. Connect the C-5300-NC Machine Start Harness to the Coin 1 connector on the Machine Control Assembly.

    Cci readerinstall kit
    KitID582
    KitDescSerial Communication / Serial Pulse

    1. Connect the C-5240 Machine Start Harness to the the H3 connection on the Machine Control Assembly or Communication board.

    Connect the C-5256 Machine Start Harness to the the harness previously connected to the coin slide microswitch spade tabs.
    Cci readerinstall kit
    KitID636
    KitDescHybrid Coin Slide Switch
    step
    componentStart

    Cci readerinstall step
    componentExtras

    ...