Versions Compared

Old Version 2

changes.mady.by.user David Bussman

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID614
KitDescCoin Model
  1. Remove coin box and coin slide.
  2. Install C-5771 Metercase Bracket into the front opening of the metercase and secure using C-0303Topload Mounting Bolt from the inside.
  3. After running the Cat5e cables and start harness through the front opening of the metercase bracket and connecting them to the LaundryCard reader, use the (2) C-0141 8-32 x 1-1/2" Socket Screws to secure the reader.
  4. Apply the C-0015 Label to the front of the LaundryCard reader around the card slot.
Cci readerinstall kit
KitID755
KitDescCard Model
  1. Use theC-0930Mounting Bracketto mark out the center opening for the card reader and the lower set of holes to the left and right of the central opening.
    1. Ensure the positing leaves enough space for the reader's bezel to sit flat against the machine's panel and for the reader to be inserted into the machine and allow for the CAT5 cables to be connected.
  2. Cut out the central opening and use a 9/64" Drill Bit to make a hole at each drill marks to the left and right of the central opening.
  3. Place the C-0930 Mounting Bracket on the inside of the machine's panel. Pass through and connect the CAT5 cables and machine start harness to the reader.
  4. Use the(2) C-0144 8-32 x 2" Flat Screwto attach the reader to the C-0930 Mounting Bracket.
  5. Apply C-0015Labelover the area around the card slot on the front of the LaundryCard reader.

Connect Machine Interface Harness

Cci readerinstall kit
KitID590
KitDescPulse - Debit/AA3 Connector
  1. Connect theC-5364 Machine Start Harness to the Debit/AA3connector on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
MultiExcerptNameLC Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of the C-5364 Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  3. Connect the the Cat5 cables running to and from the adjacent machinesto ports labeled 3 (Line Connection Ports) as shown in the image above.

  4. Secure the LaundryCard reader to the bracket using included hardware.

Machine Configuration

Multiexcerpt include
SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
MultiExcerptNameMayTag Gen1 MLV+ Pulse
PageWithExcerpt_Machine Configuration

Cci readerinstall footer