Versions Compared

Old Version 2

changes.mady.by.user Adam Arafat

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID917
KitDescCoin and Card

  1. Place theC-5700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Connect Power

Cci readerinstall kit
KitID595
KitDescTap Machine Power
  1. Use the C-5101 Spade Tapson the incoming power.
    1. Tap theL1wire.
    2. Tap theN / L2wire.
    3. Tap theGround wire.
  2. Take the C-5210 Power Adapter Harnessand connect the red tab connectors to the following wires:
    1. Connect thebluewire to theL1wire.
    2. Connect thebrownwire to the N / L2wire.
    3. Connect the green/yellow wire to theGroundwire.
  3. Connect the 3-pin connector from the C-5210 Power Adapter Harnessto the matching connection on the C-5602R1Power Converter.
  4. Connect the4-pinconnector from the C-5602R1 Power Converterto the matching connection on the C-5500Power Extension Harness.

Connect Coin Sense Harness

Cci readerinstall kit
KitID689
KitDescOptical Coin (Edge Connector)
  1. Disconnect the Coin Drop from the metercase coin board.
  2. Connect theC-5357 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID814
KitDescSerial - RS232 Connection
  1. Connect theC-0126-MLV Machine Start Harness to the RS-232 port on the Machine Control Assembly.
  2. Connect the C-5359 Machine Start Harnessto the Input 1port on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF1 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of the C-5359 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the free end of the C-0126-MLV Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  4. (Coin and Card Installation Only) Connect the free end of the C-5357 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  5. Connect the free end of the C-5500 Power Extension Harness to port 4 (Power Harness Connection Port) as shown in the image above.
Cci readerinstall footer