Overview
| Multiexcerpt | ||
|---|---|---|
| ||
This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below. |
Install Header
...
| MultiExcerptName | Install Header |
|---|
...
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Required Hardware
Card Reader
F2 Install Header
...
| MultiExcerptName | F2 Install Header |
|---|
...
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Required Hardware
Card Reader
Reader Ports
...
| MultiExcerptName | Reader ports |
|---|
F2 Reader Ports
...
| MultiExcerptName | F2 Reader Ports |
|---|
...
Additional Info
...
| MultiExcerptName | Additional Info |
|---|
...
Additional Information
...
Unverified
| Multiexcerpt | ||
|---|---|---|
| ||
These instructions and kit hardware have not been verified or tested by Card Concepts Inc. and are used at the installers own risk. |
ACA Dip Switches
...
ACA Dip Switches
| Excerpt | ||
|---|---|---|
| ||
ACA machines using a serial configuration require dip switch 3 on the Machine Control AssemblyBoard to be set to the 'ON' position. All Leave all other dip switches should remain in the 'OFF' positionas is. |
ACA Card Ready
| Multiexcerptexcerpt | ||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||
ACA Card Ready machines using a pulse configuration require a retrofit to a Coin-Ready state. This may require obtaining an additional Coin Sense Harness from Alliance. | ||||||||||||||||||||||
| Multiexcerpt | ||||||||||||||||||||||
| ||||||||||||||||||||||
Description Link/Source Image | Champion CT7-1-1/8 Tungsten Carbide Tipped 1-1/8-Inch Hole Cutter-1-Inch Thick Metal (Or Equivalent) | Cutting Oil | Amazon | 9/64" Drill Bit (Optional) | Amazon | Heavy Duty Professional 3/8" Magnesium Drill with #2 drill tip extension. (Or Equivalent) | Harbor Freight | Center Punch (Or Equivalent) | Amazon | Hammer | Amazon | Fine Point Sharpie Marker (Or Equivalent) | Amazon | Pliers (Or Equivalent) | Amazon | Tape Measure | Amazon | C-5700-TEMP FasCard Drill Template *Included in C-1490 Kit | CCI