Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID841
    KitDescCoin and Card
    componentMounting

    cci-readerinstall-kit
    KitID842
    KitDescCard Only

    1. Remove existing coin box and coin drop.

    2. Install C-0905 Drop Cover where the coin drop was previously mounted. Secure in place using the existing hardware.
    3. Align the C-5414 Mounting Bracket with the C-6936 Vault Bracket with the C-5414 Mounting Bracket on top. Run all reader harnesses through the holes in the brackets.

    4. Bend the side tabs of the C-6936 Vault Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

    5. Attach C-5414 Mounting Bracket to the C-6936 Vault Bracket using C-0144 Screws.

    ...

    step
    componentPower

    Tap power as described in the document by connecting the C-5211 Power Adapter Harness to the male spade connectors on the machine power panel.
    1. Connect the green wire to the ground terminal.
    2. A corner of the power panel cover may need to be bent slightly to allow the power harness egress.
  • Connect the opposite end of the C-5211 Power Adapter Harness to the C-5602 Power Converter.
  • Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    • cci-readerinstall-kit
    KitID805

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID704
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    componentStart

    cci-readerinstall-kit
    KitID636
    KitDescPulse
    1. Connect the C-5256 Machine Start Harness to the harness previously connected to the micro switch.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the F2: FasCard Reader Mounting Guide.
    2. Connect the free end of the C-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500-60 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    step
    componentReader

    Cci readerinstall footer