Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card

    Connect Power

    componentMounting

    Tap power as described in the document by connecting the C-5210 Power Adapter Harness to the power distribution panel inside the machine.

    1. 120vac: Connect the blue wire to L1 and the brown wire to N.

    2. 240vac: Connect the brown and blue wires to L1 and L2 wires.

    3. Connect the green wire to the ground wire.

  • Connect the opposite end of the C-5210 Power Adapter Harness to the C-5602 Power Converter.

  • Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    • cci-readerinstall-kitstep
    KitID595

    Connect Coin Sense Harness

    componentPower

  • Disconnect the Coin Drop from the Machine Control Assembly.
    • Connect the C-6389 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kit
    KitID725
    KitDescCoin Drop: Set-O-Matic
    step
    componentCoin Sense

    Cci readerinstall kit
    KitID890
    KitDescCoin Drop: Keltner SR1-WIR

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the 6-pin male connector from the C-6380 Coin Sense Harness to the 6-pin female connector on the harness connected to the Coin Drop.

    ...

    Connect the C-5388 Machine Start Harness to the coin connector on the Machine Control Assembly.
    cci-readerinstall-kit
    KitID666
    KitDescPulse - Set-O-Matic
    step
    componentStart

    Cci readerinstall kit
    KitID890
    KitDescPulse - Keltner SR1-WIR

    1. Connect the 6-pin female connector from the C-6380 Machine Start Harness to the 6-pin male coin connector on the Machine Control Assembly.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Machine Configuration

    ...

    Cci readerinstall step
    componentReader

    Cci readerinstall footer