Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitIDcomponent584
    KitDescCoin and Card
    Mounting

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
  • Optional: Apply C-5035 Label over card slot.
    • cci-readerinstall-kit
    KitID976
    KitDescCard Only - Card Ready

    ...

    step
    componentPower

    Tap power as described in the document by connecting theC-5210 Power Adapter Harnessto the incoming power wires.

    1. 120vac: Tap and connect the blue wire to L1 and the brown wire to N.

    2. 240vac: Tap and connect the brown and blue wires to connectors L1 and L2 wires.

    3. Tap and connect the green wire to the ground wire.

    Connect the opposite end of theC-5210 Power Adapter Harnessto theC-5602 Power Converter.Connect theC-5500Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kit
    KitID595

    ...

    step
    componentCoin Sense

    cci-readerinstall-kit
    KitID700
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Connect the C-5272 Machine Start Harness to the Coin 1 connector in the metercase.
    Cci readerinstall kit
    KitID642
    KitDescPulse
    step
    componentStart

    cci-readerinstall-kitstep
    KitID643
    KitDescSerial
    1. Connect the C-5274R1 Machine Start Harness to the Serial Communication Harness behind the control panel.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. For pulse start harnesses (white connector), connect to port 2 (Pulse Connection Port) as shown in the image above.
    2. For serial start harnesses (black connector), connect to port 5 (Serial Connection Port) as shown in the image above.

    ...

    Machine Configuration

    ...

    componentReader

    Cci readerinstall footer