Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Remove existing coin box.

  • Insert the C-5710 Rubber Grommet into the central hole of the C-6936 Vault Bracket.
  • Run all reader harnesses through coin vault and then the hole of the C-6936 Vault Bracket.

  • Bend the side tabs of the C-6936 Vault Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

  • Run all reader harnesses through the central hole of the C-5414 Reader Bracket.
    • Attach the C-5414 Reader Bracket to the C-6936 Vault Bracketusing the C-0144 screw.
    cci-readerinstall-kitstep
    KitIDcomponent992
    KitDescCard Only

    Connect Power

    Mounting

    Tap power as described in the document by connecting the C-5213 Power Adapter Harness to the power distribution terminal block inside the machine.

    1. Connect the black wire to a L1 tab.

    2. Connect the white wire to a L2 tab.

    3. Connect the Green/Yellow wire to the ground tab.

  • Connect the opposite end of the C-5213 Power Adapter Harness to the C-5602R1 Power Converter.

  • Connect the C-5500-115 Power Extension Harness to the appropriate connector on the C-5602R1 Power Converter. The remaining cable end connects to the FasCard reader.

    • cci-readerinstall-kitstep
    KitID617

    ...

    componentPower

    cci-readerinstall-kit
    KitID707
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6258 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    step
    componentCoin Sense

    cci-readerinstall-kit
    KitID634
    KitDescPulse
    1. Connect the C-5257 Machine Start Harness to the P2 connector on the Machine Control Assembly.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the Touchscreen Reader Mounting Guide (F2 & F3).
    2. Connect the free end of the C-5254 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6258 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500-114 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the Touchscreen Reader Mounting Guide (F2 & F3).

    Machine Configuration

    ...

    step
    componentStart

    Cci readerinstall step
    componentReader

    Cci readerinstall footer