Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card
    componentMounting

    Install the C-0961 Jam Ring into the coin vault. TheJam Ring should be installed into the coin vault so that it is within 1.5" of front panel of the machine to allow the mounting bracket to be attached.To install theJam Ring insert the ring so the small portion is on the bottom. Insert at an angle, so the top of theJam Ring is inserted first. Once the ring is in position, pull the top of theJam Ring towards the front of the machine until it locks into place.
  • Using the C-5751 Screws, attach the C-6960 Mounting Bracket to the C-0961 Jam Ring.
  • Attach the C-5414 Standard Mounting Bracketto the C-6960 Mounting Bracketusing the C-5420 Screws.
    cci-readerinstall-kitstep
    KitID872
    KitDescCard Only

    ...

    componentPower

    Tap power as described in the document using theC-5101 Spade Taps provided.Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.Connect theC-5500-60 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kit
    KitID802

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitIDcomponent704
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Start

    Connect the C-5256 Machine Start Harness to the harness that was previously connected to theCoin Drop.
    cci-readerinstall-kit
    KitID636
    KitDescPulse

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the F2: FasCard Reader Mounting Guide.
    2. Connect the free end of the C-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500-60 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    step
    componentReader

    Cci readerinstall footer