Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.Install theC-5702Chase Nippleinto theC-5414F2 Mounting Bracketusing theC-5703Nut.Feed the remaining harness ends through the open face of theCoin Vault.Spread theC-6936Vault Mount Bracketwings outward before insertion to lock bracket into place.Feed remaining harness ends through theC-6936Vault Mount Bracket.Insert theC-6936Vault Mount Bracketinto theCoin Vault.Feed the remaining harness ends through the combinedC-5414F2 Mounting Bracket.Secure the combinedC-5414F2 Mounting Bracketto theC-6939 Vault Mount Bracket with theC-0144Screws.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID667
    KitDescCard Only

    Connect Power

    ...

    KitID473

    ...

    1. 120vac- Connect Brown and Blue wires to connector #2 closest to outside of machine and #4 on terminal side closest to circuit board.
    2. 240vac- Connect Brown and Blue wires to connectors 3 and 5 on the terminal side closest to the circuit board.
    3. Secure the green wire beneath the ground screw.

    ...

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID704
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.
    Cci readerinstall kit
    KitID723
    KitDescCoin Drop: Imonex
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6382 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID636
    KitDescPulse
    1. Connect the C-5256 Machine Start Harness to the factory coin drop harness previously connected to the microswitch.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the F2: FasCard Reader Mounting Guide.
    2. Connect the free end of the C-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    step
    componentMounting

    Cci readerinstall step
    componentPower

    Cci readerinstall step
    componentCoin Sense

    Cci readerinstall step
    componentStart

    Cci readerinstall step
    componentReader

    Cci readerinstall footer