Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Place theC-6700-TEMPDrill Template on the desired mounting location.
  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card
    componentMounting

  • Remove existing coin box and coin drop.

  • Secure C-5414 F2 Mounting Bracketto the C-6903Mounting Bracket using the(2)C-542010-32 x 1/4 Pan Screws.Install theC-6903Mounting Bracketinto theCoin Vault. Use (4) C-1042Kep Nuts to secure toCoin Vault.
    cci-readerinstall-kitstep
    KitID845
    KitDescCard Only

    ...

    componentPower

    Tap power as described in the document using theC-5101 Spade Taps provided.Connect theC-5336 Power Adapter Harness to the installed spade taps-BluetoBlack and BrowntoRed. Secure the green ground terminal under the bolt on top of the washer drum.Connect the opposite end of theC-5336Power Adapter Harnessto theC-5602 Power Converter.Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kit
    KitID663
    KitDescTap Machine Power

    ...

    step
    componentCoin Sense

  • Disconnect the Coin Drop from the Machine Control Assembly.
  • Connect theC-6332 Coin Sense Harness to the harness connected to the Coin Drop.Connect the Redconnector to the Coin Acceptorconnection, where the coin drop was previously connected, on the Machine Control Assembly.
    cci-readerinstall-kitstep
    KitID923
    KitDescCoin Drop - Factory Optical

    Connect Machine Interface Harness

    componentStart

    Connect the C-0114-MLV Machine Start Harness to the middle X1 port on the serial communication board.
    CCIDOCCOM Boardsfalse
    cci-readerinstall-kit
    KitID608
    KitDescSerial

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    step
    componentReader

    Machine Configuration

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameContinental ProfitPlus
    PageWithExcerpt_Machine Configuration

    ...