Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitIDcomponent584
    KitDescCoin and Card
    Mounting

  • Remove existing coin box and coin drop.

  • Install the C-0913 Drop Cover in the coin drop opening and secure using the C-1062 Keps Nuts.
    • Run all reader harnesses through coin vault and then the hole of theC-6936Vault Bracket.Bend the side tabs of theC-6936Vault Bracketoutward and install into the coin vault. The tabs should snap into place securing the bracket.Run all reader harnesses through the central hole of theC-5414Reader Bracket. Attach theC-5414Reader Bracketto theC-6936Vault Bracketusing theC-0144screw so that it is flush with the front panel.
    cci-readerinstall-kit
    KitID940
    KitDescCard Only - Coin Model
    Cci readerinstall kit
    KitID995
    KitDescCard Only - Card Model

    1. Remove factory card reader interface bracket.

    2. Attach C-5414 Reader Bracket to the C-6918 Mounting Bracket using (2) C-5420 10-32 x 1/4" Pan Screw.
    3. Install the C-6918 Mounting Bracket in the payment device opening and secure using the (2) C-1062 Keps Nuts.
    4. Run all reader harnesses through the center hole in the C-6918 Mounting Bracket.

    ...

    step
    componentPower

    Use the C-5101 Spade Tapson the incoming power.Tap theL1wire.Tap theN / L2wire.Tap theGround wire.Take the C-5210 Power Adapter Harnessand connect the red tab connectors to the following wires:Connect thebluewire to theL1wire.Connect thebrownwire to theN / L2wire.Connect the green/yellow wire to theGroundwire.Connect the 3-pin connector from the C-5210 Power Adapter Harnessto the matching connection on the C-5602R1Power Converter.Connect the4-pinconnector from the C-5602R1 Power Converterto the matching connection on the C-5500Power Extension Harness.
    cci-readerinstall-kit
    KitID595
    KitDescTap Machine Power

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID721
    KitDescFactory Coin Drop
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6362 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    componentStart

    Connect the C-5370 Machine Start Harness to the 8-pin J6 harness connection accessible near the coin drop.
    cci-readerinstall-kit
    KitID997
    KitDescPulse - AA3/Debit Connection

    Connect and Mount Reader

    ...

    step
    componentReader

    Machine Configuration

    1. Enter Service Mode and navigate to J option.

    2. Set option to J.d.

    3. Exit Service Mode.

    Cci readerinstall footer