Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
  • Remove existing coin box.

  • Remove Vault Switchand bridge the wires previously connected to the Vault Switchwith the C-5365 Bypass Harness.Bend the side tabs of theC-6936Vault Bracketoutward and install into the coin vault. The tabs should snap into place securing the bracket.Secure the C-5414 Standard Mounting Bracket to the C-6936Vault Bracket with C-0144 Screws.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID856
    KitDescCard Only - Coin Ready Models
    step
    componentMounting

    Install the C-6970Alliance Mounting Bracketinto the opening on the control panel for mounting card readers and coin drops.Attach the C-5414F2 Mounting Bracketto the C-6970Alliance Mounting Bracketand secure using the C-1060Screws.Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID865
    KitDescCard Only - Card Ready Models

    ...

    componentPower

    cci-readerinstall-kitstep
    KitID581
    1. Connect the C-6204-40 Power Adapter Harness (12VDC power) to the H10 connection on the Machine Control Assembly.

      1. Secure the green wire beneath the ground screw.

    ...

    componentCoin Sense

  • Disconnect the coin drop from the machine control assembly.
  • Connect the C-6250 Coin Sense Harness to the harness connected to the coin drop.
    cci-readerinstall-kitstep
    KitID700
    KitDescCoin Drop: Factory
    componentStart

    cci-readerinstall-kitstep
    KitIDcomponent928
    KitDescCoin Drop: Factory - Dual Coin
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 1 Drop.
    3. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 2 Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID582
    KitDescPulse and Serial
    1. Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.

    ...

    Reader

    Machine Configuration

    ...

    Machine Configuration

    ACA machines using a serial configuration require dip switch 3 on theMachine Control Boardto be set to the 'ON' position.Leave all other dip switches as is.

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. If using a dual coin drop, connect the second C-6250 Coin Sense Harness to port 4 (Coin 2 Sense Harness Connection Port) as shown in the image above.

    ...

    com.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
    MultiExcerptNameACA Configuration
    PageWithExcerpt_Machine Configuration

    Cci readerinstall footer