Versions Compared

Version Old Version 3 New Version Current
Changes made by

CCI Integration User

Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.

    Coin Ready

  • Remove existing coin box.

  • Bend the side tabs of the C-6602 Vault Mount Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

    • Use the C-0144 Screws, attach the C-5414 F2 Mounting Bracket to the C-6602Vault Mount Bracket
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID863
    KitDescCard Only
    step
    componentMounting

    cci-readerinstall-kit
    KitID865
    KitDescCard Ready
    1. Install the C-6970 Bracket on the control panel.
    2. Attach the C-5414 F2 Mounting Bracket onto the C-6970 Bracket using the C-1060 screws.

    ...

    step
    componentPower

    cci-readerinstall-kitstep
    KitID581

    1. Connect the C-6204-40 12VDC Power Harness to the H10 connection on the machine control assembly.

      1. Secure the green wire beneath the ground screw.

    2. Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) to the F2 reader.

    ...

    componentCoin Sense

  • Disconnect the Coin Drop from the Machine Control Assembly.
    • Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kitstep
    KitID700
    KitDescCoin Drop: Factory
    componentStart

  • Disconnect the Coin Drop from the Machine Control Assembly.
    • Connect aC-6250 Coin Sense Harness to the harness connected to the Coin 1 Drop.Connect aC-6250 Coin Sense Harness to the harness connected to the Coin 2 Drop.
    cci-readerinstall-kitstep
    KitID928
    KitDescCoin Drop: Factory - Dual Coin

    Connect Machine Interface Harness

    componentExtras

    cci-readerinstall-kit
    KitID645
    KitDescPulse
    1. Connect the C-5300-NC Machine Start Harness to the Machine Control Assembly.
    Cci readerinstall kit
    KitID582
    KitDescSerial
    1. Connect the C-5240 Machine Start Harness to the Machine Control Assembly.

    For Card only

    1. Connect the C-5365 Bypass Harness to the appropriate connections to bypass the coin vault switch. **Needs Better Verbiage)

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    step
    componentReader

    Machine Configuration

    ACA machines using a serial configuration require dip switch 3 on the Machine Control Board to be set to the 'ON' position. Leave all other dip switches as is.

    ...