Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card
    componentMounting

  • Disconnect wires connected to vault service switch and bridge connection using C-5365 Bypass Harness.

  • Remove the front control Panel and pull panel away from machine exposing the factory plate / Coin Drop

    • Loosen the two (2) left retaining screws (Green) and remove the remaining screws on the bracket (Blue) and slide the bracket off the machine.
    Slide the C-6965 QT Mounting Bracket onto the loose screws and tighten. Add remaining screws to the corresponding holes on the bracket and tighten.
  • Re-secure the front panel to the machine.
    • Attach the C-5414 Reader Bracket to the C-6965 QT Mounting Bracket using C-5702 Chase Nipple and C-5703 Nut.
    Feed all reader harnesses through the center hole.
    cci-readerinstall-kit
    KitID982
    KitDescCard Only

    ...

    step
    componentPower

    Connect the C-6204-40 Power Adapter Harnessto the H10 connection on the machine control board.

  • Secure the green wire beneath the ground screw.

  • Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) into the back of the F1 Reader.

    • cci-readerinstall-kitstep
    KitID581

    ...

    componentCoin Sense

    cci-readerinstall-kitstep
    KitID700
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    componentStart

    Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.
    cci-readerinstall-kitstep
    KitIDcomponent582
    KitDescSerial or Pulse

    ...

    Reader

    Machine Configuration

    Multiexcerpt include
    SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
    MultiExcerptNameF2 ReaderMidas
    PageWithExcerpt_Reader Ports

    ...

    Machine

    ...

    Configuration

    ...

    TODO

    Cci readerinstall footer